Pools, Useful info, Useful tips

Pool Robot – How to Choose a Model for Your Pool

RobotVac Fraser AKU robot in water – top view

A pool robot is chosen by the floor area, the depth and whether you want a cable to the mains socket. First compare the size of your pool with the coverage of the model. Then check the run time, the basket capacity and the permitted water conditions. At Baseini.NET we offer rechargeable models from Mountfield, Aiper and POOLSANA.

In short:

  • The size of the pool decides the first choice: Trinity is for up to 15 m², Colorado for up to 65 m², and Fraser for up to 170 m².
  • A rechargeable robot has no cable to the mains socket, so there is no mains-powered device in the water.
  • The run time is at least 120 minutes for Fraser and Orinoco and a 2-hour cycle for Warrior AKU.
  • The water must be within the limits of the model: for example pH from 7.0 to 7.6 and chlorine up to 4 ppm for Warrior AKU.
  • The robot is not for a pool full of leaves and algae: large debris is collected first with a skimmer net.

How do you choose a pool robot by size?

The size of the pool is compared with the floor area that the manufacturer specifies for the model. Measure the length and width of the pool and multiply them. This gives you the floor area. It must not be larger than the coverage of the chosen model.

Depth matters too. Warrior AKU works to a depth of 2.5 m, Fraser is also for a depth of up to 2.5 m, and Orinoco and POOLSANA C11P Pathfinder – up to 3 m. The shape is also taken into account: Orinoco is for pools with a flat floor, and Trinity is for small flat pools.

The models can be browsed in the pool cleaners and robots category. If you are not sure, write to us with the size and type of your pool and we will help you choose.

Акумулаторен робот за басейн SupraVac Colorado AKU с лилава дръжка и колела, изглед отпред

Which pool robot is for a small, medium and large pool?

For a small pool of up to 15 m², the SupraVac Trinity mini model is suitable, and for a large pool of up to 170–180 m² there are Fraser and Orinoco. The table shows the Mountfield and POOLSANA models with the area they are designed for.

ModelFloor areaWhat sets it apart
SupraVac Trinity AKUup to 15 m² (up to 5.5 × 3.5 m)mini model for small flat pools, up to 110 min run time
Azuro Warrior AKUup to 50 m² (up to 10 × 5 m)floating battery, 2 h cycle, depth up to 2.5 m
SupraVac Colorado AKUup to 65 m²pool diameter up to 9 m, 4.5 l container
POOLSANA C11P Pathfinderup to 120 m²app control, depth up to 3 m
RobotVac Fraser AKUup to 170 m²three modes, at least 120 min run time, 4 l container
RobotVac Orinoco AKUup to 180 m² (flat floor)weekly mode, app, three motors

For the largest pools there are also Aiper models. The Aiper Scuba X1 Pro is for in-ground pools up to 200 m² and runs for up to 180 minutes on a single charge. It also cleans steps, slopes and raised platforms. Details are on the page of the Aiper Scuba X1 Pro with ultrasonic mapping.

When is a rechargeable robot suitable?

A rechargeable robot is suitable when you do not want a cable around the pool and extension leads to the socket. The battery is inside the unit or floats on the surface, so nothing gets tangled. Warrior AKU uses a 28.8 V floating battery connected to the robot with a 3 m cable.

Azuro Warrior AKU cleans the floor, the walls and the waterline. It is also suitable for salt water – up to 4000 ppm salt. It weighs 7.5 kg and switches itself off after the 2-hour cycle.

RobotVac Fraser AKU with three modes charges in 2–3 hours and runs for at least 120 minutes. The Fraser rechargeable robot has a 180 micron filter and a 4 l container. Orinoco charges in about 5 hours and can also be controlled from a mobile app.

Изплакване на филтърния контейнер на акумулаторен робот с градински маркуч

With the RobotVac Orinoco with mobile app, the weekly mode repeats a short floor cycle at a set time. It starts only when the battery charge is at least 80%. The Orinoco robot stops by itself at the pool wall.

In what water conditions does the robot work?

Every model has limits for temperature, pH and chlorine, and they must be observed. For Warrior AKU the water is from 5 to 36 °C, pH from 7.0 to 7.6 and chlorine up to 4 ppm. Salt is permitted up to 4000 ppm.

POOLSANA C11P Pathfinder works in water from 15 to 35 °C, pH from 7.0 to 7.8 and chlorine up to 4 ppm. Orinoco permits salt up to 5000 ppm. It also requires chlorine up to 4 ppm, and pH from 7.0 to 8.8.

There are also restrictions on the use itself. The Warrior AKU robot is not started when there are people in the pool or a counter-current system is running. During shock disinfection of the water, the robot is removed from the pool. With Orinoco, do not switch the unit on while the pool filtration is running.

Steps or sun terraces under 50 cm of water can make things difficult for Orinoco. So check how the pool floor is shaped before you order.

How do you put the robot in the pool and look after it?

The robot is put into the pool in a few steps, and after the cycle it is taken out and rinsed. Here is the order for Warrior AKU:

  1. Charge the battery with the charger: the red light shows charging, the green one that it is charged.
  2. Then connect the robot’s cable to the floating battery and tighten the nut by hand.
  3. Place the robot in the pool and wait until it settles on the bottom.
  4. Press the button on top of the battery to start the two-hour cycle.
  5. After the cycle, pull the battery to the edge, then pull out the cable and the robot by the handle.

The Warrior AKU charger is plugged in at least 3.5 m from the pool, into a socket with a 30 mA residual-current device. The set includes a retrieval hook that attaches to a telescopic pole. The pole is not included.

The Orinoco filter basket is rinsed after every cleaning. For Trinity, the manufacturer recommends rinsing with clean water after every use. Do not use solvents and aggressive cleaning agents. Dry the robot in a place without direct sunlight and charge the battery immediately after use.

Акумулаторен робот за басейн Azuro Warrior AKU в светлосин цвят с гумени вериги и четки

The Warrior AKU robot is not intended for a pool full of algae and leaves after winter. First collect the large debris with a skimmer net. If the water is cloudy, read how to clear cloudy pool water.

Frequently asked questions

Frequently asked questions

What pool robot is suitable for a small pool?

For a small flat pool of up to 5.5 × 3.5 m (up to 15 m²), the SupraVac Trinity AKU mini model is designed. It runs for up to 110 minutes and has a 180 micron filter. It charges in 5–6 hours.

Does a pool robot have to be connected to a socket?

Rechargeable models work without a cable to the mains socket. Warrior AKU is powered by a floating battery that is charged beforehand. The charger is plugged in away from the pool, not in the water.

How long does a rechargeable robot run on one charge?

RobotVac Fraser AKU and RobotVac Orinoco AKU run for at least 120 minutes. Warrior AKU has a 2-hour cycle and then switches off by itself. Aiper Scuba X1 Pro runs for up to 180 minutes.

Can the robot clean a saltwater pool?

Yes, with some models. Warrior AKU is suitable for salt up to 4000 ppm, and Orinoco up to 5000 ppm. For POOLSANA C11P Pathfinder the permitted salt is up to 0.5%.

When is the robot taken out of the pool?

The robot is taken out during shock disinfection of the water, when there are people in the pool and when a counter-current system is running. After the cycle you take it out and rinse the basket. That way it is ready for the next cleaning.

About the author: Rumyana Borisova is the founder of Baseini.NET and has been an expert in the construction and maintenance of swimming pools, hot tubs and saunas since 2006, as the exclusive representative of Mountfield. She gives expert commentary about pool water on bTV, Nova TV, BNT (Bulgarian National Television), in the “Telegraph” newspaper and on Radio “Focus”. “Businesswoman of the Year 2023” and recipient of the Women Leaders Awards 2025.